The SoloLX kits have been redesigned specifically for the SX435W and WF7015 series of printers (other printers will no doubt be added to the list in the future)
[See compatibility information below]

Similar to the SoloX and SoloX10 the kit design includes a tube part that can be split and threaded through an enlarged screw hole in the back of the printer while leaving the L' shaped connector inside to act as a strain relief.

Note: This kit will not fit a printer that has two waste ink tubes (eg: R1800, R2400, B40, BX600FW) and are not recommended for SoloX or Solo+/+2 compatible printers

IMPORTANT:
This product listing does not include the means to reset your printers waste ink counter. It is intended for customers who have or who intend to source the necessary reset utility/service themselves.
Click here for this Waste Kit + Reset Key bundle

Design Features:

• 35cm (13.7") single tube (in 15cm + 20cm parts)
• Two part design allows insertion through enlarged screw hole
• L' Shaped (Elbow) Connector between parts acts as strain relief, protecting against accidental pulling on tubing/tank
• The valve closes automatically when the waste tube fitting is unscrewed
• A tight liquid proof seal around the fitting stops any leakage
• Simple to install, easy to maintain.
• Tanks are all re-usable after emptying
• Vent hole to allow any air out automatically (No need to vent a bag regularly).
• The location and size of the vent hole allows for accidents as the waste tank can effectively fall and hang from the waste tube with minimal, if any, spillage.

Compatibility:

This kit has been designed specifically for the following series of printers

• SX435W, SX445W
• Workforce WF7015
• ...other models are expected to be compatible pending additional research

If you haven't used it already, then please use the "QuickFind" tool to identify whether this kit will fit your printer.

Instructions

Instructions on how to install this kit are available

Product Specification

• Pre-fitted valve, and liquid-tight fitting
• Extension/Connection tube, pre-assembled with:
  • Tygon tubing 35cm (minimum) total length
  • 1x Tube clamp
  • 2x Barbed tube connector
    • 1x Connect to printer waste tube
    • 1x L' shaped (Elbow) connects both parts of kit tubing

Tank Options

• 180ml / 350ml rigid Box
  ..OR..
  
• 220ml strong flexible Bag
• 1x "Vent" fitting (for emptying air/ink from bag as required)

Boxes and Bag tanks are all interchangeable thanks to the valve/connection system used